Adhesive guide

1. Apply the adhesive

Before applying the adhesive, please make sure you clean the skin area to which you will attach the packer. You need to remove hair from this part of the body, and the Applying the adhesive on FTM packerskin needs to be cleaned properly to make sure the packer is attached perfectly. You can use any type of body wash or wet wipes for this purpose. Once you clean the skin, let it dry for a few seconds.

For more information check this Blog post.

 2. packer position

FTM packer attached to the body

Once you applied the adhesive, attach your packer to the body and position it carefully. Please try to make sure that you attach it in the right position and try not to move it around for too long, as the adhesive may start to cure. After you position the packer, then let it dry for a few minutes.

Try it a few times at home to master your technique so you’ll know what to expect and feel more confident when you need the S.T.P on the go. Don’t get discouraged if you dribble the first time or two. With a little practice, the Stand To Pee device will work perfectly every time.